LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> RAV4 Base, 3.5 K, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio System & Visual System >> Rear Seat Entertainment System >> Television Display Power Source Circuit >> Inspection Procedure

Inspection Procedure

  1. CHECK WIRE HARNESS (TELEVISION DISPLAY - BATTERY AND BODY GROUND) 
    1. Disconnect the L16 display connector.
    2. Measure the resistance of the wire harness side connector.

      Standard resistance 

      STANDARD RESISTANCE SPECIFICATIONS

      Tester Connection Specified Condition
      L16-12 (GND) - Body ground Below 1 Ω
    3. Measure the voltage of the wire harness side connector.

    Standard voltage 

    STANDARD VOLTAGE SPECIFICATIONS

    Tester Connection Condition Specified Condition
    L16-16 (+B) - Body ground Always 10 to 14 V
    L16-15 (ACC) - Body ground Ignition switch on (ACC) 10 to 14 V

    NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

    Fig 1: Identifying L16 Display Connector Terminals
    G05184832Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN  PROBLEM SYMPTOMS TABLE  

scientia non olet · About LEMON Manuals