LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> RAV4 Base, 2.4 D, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2AZ-FE) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE GENERATOR ASSEMBLY 
    1. Remove the generator assembly from the vehicle (See REMOVAL ).
  3. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the connector clamp.
    3. Remove the wire harness from the wire harness clamp bracket.
    4. Remove the wire harness clamp.
    5. Remove the bolt and sensor.
    Fig 1: Disconnecting Sensor Connector
    G05183813Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals