LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> RAV4 Base, 2.4 D, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2AZ-FE) >> Camshaft Position Sensor >> Removal

Camshaft Position Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE NO. 1 ENGINE COVER  (see REMOVAL )
  3. REMOVE AIR CLEANER CAP  (see REMOVAL )
  4. REMOVE CAMSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
    Fig 1: Locating Camshaft Position Sensor Bolt
    G04973355Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals