Fuel Pump: Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT FUEL PUMP
1. Check the fuel pump resistance.
  1. Measure the resistance between terminals 1 and 2.
    Standard resistance: 0.2 to 3.0 Ω at 20°C (68°F)
    
    If the result is not as specified, replace the fuel pump.
    
    Fig 1: Measuring Resistance Between Terminals 1 And 2
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check fuel pump operation.
  1. Apply battery voltage to terminals 1 and 2. Check that the pump operates.
    NOTE:
    These tests must be completed within 10 seconds to prevent the coil from burning out.
    
    Keep the fuel pump as far away from the battery as possible.
    
    Always turn the voltage on and off on the battery side, not the fuel pump side.
    If the pump does not operate, replace the fuel pump.