Center Airbag Sensor Assembly: Installation

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see AIRBAG SYSTEM  ).

Fig 1: Locating Center Airbag Sensor Assembly Bolts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY 
   1. Install the airbag sensor with the 3 bolts.

      Torque: 17.5 N*m (178 kgf*cm, 13 ft.*lbf) 

      CAUTION:

      • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
      • When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
   2. Connect the airbag sensor connectors.
      Fig 2: Locating Center Airbag Sensor Assembly Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 3 AIR DUCT REAR 
3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See  INSTALLATION  ) 
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
5. PERFORM INITIALIZATION 
   1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
6. CHECK SRS WARNING LIGHT 
   1. Check the SRS warning light (see DIAGNOSIS SYSTEM  ).