Floor Shift Lever Assembly: Installation

INSTALL FLOOR SHIFT LEVER ASSEMBLY
1. Install the shift lever assembly with the 4 nuts.
  Torque: 12 N*m (120 kgf*cm, 9 ft.*lbf)
  
  Fig 1: Locating Floor Shift Lever Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT
1. Connect the select cable to the shift lever assembly.
  NOTE:
  - The projecting part of the cable outer should face upward when the shift cable is installed.
  - Make sure that after installation the cable outer spring is moved to the place shown in the illustration.
    
    Fig 2: Connecting Select Cable To Shift Lever Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the select cable end with the clip to the shift lever assembly.
3. Connect the select cable to the clamp.
  
  Fig 3: Connecting Select Cable End With Clip To Shift Lever Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT
1. Connect the shift cable with the clip to the shift lever assembly.
  NOTE:
  - The projecting part of the cable outer should face upward when the shift cable is installed.
  - Make sure that after installation the cable outer spring is moved to the place shown in the illustration.
    
    Fig 4: Connecting Shift Cable To Shift Lever Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the shift cable end as shown in the illustration.
  
  Fig 5: Identifying Shift Cable End
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the washer and clip.
4. Connect the shift cable to the clamp.
INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See INSTALLATION )
INSTALL INSTRUMENT PANEL BOX (See INSTALLATION )
INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CTR (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY