Floor Shift Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL FLOOR SHIFT ASSEMBLY
1. Install the floor shift assembly with the 4 nuts
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
  
  HINT:
  
  Tighten them in the order, A, B, C and D.
  
  Fig 1: Locating Floor Shift Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the shift lock control ECU connector and indicator light wire connector.
3. Connect the wire harness clamp.
  
  Fig 2: Locating Shift Lock Control ECU Connector And Indicator Light Wire Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
1. Install the control cable to the shift lever plate.
  
  Fig 3: Identifying Transmission Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the control cable end to the floor shift assembly.
  HINT:
  
  Install it with the uneven surface facing up.
  
  Fig 4: Locating Control Cable End
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY
1. Pass the parking lock cable through the hole of shift lever plate.
2. Insert the slide cap into the shift lever plate.
  
  Fig 5: Identifying Slide Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Apply MP grease to the shift lock release link.
4. Insert the lever pin into the hole in the cable end.
CHECK KEY INTERLOCK OPERATION
HINT:

(See ON-VEHICLE INSPECTION )
CHECK SHIFT LOCK OPERATION
HINT:

(See ON-VEHICLE INSPECTION )
CHECK SHIFT LOCK RELEASE BUTTON OPERATION
HINT:

(See ON-VEHICLE INSPECTION )