LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Matrix Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (1ZZ-FE) >> Oil Pump >> Installation

Oil Pump: Installation

  1. INSTALL OIL PUMP ASSEMBLY 
    1. Install a new gasket onto the cylinder block.
      Fig 1: Identifying Gasket On Cylinder Block
      G05193408Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Align the spline teeth of the oil pump drive rotor with the large teeth of the crankshaft, then slide on the oil pump.
    3. Install the oil pump with the 5 bolts.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      Fig 2: Aligning Spline Teeth Of Oil Pump Drive Rotor With Crankshaft
      G05193420Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CHAIN VIBRATION DAMPER NO.1 

    Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

  3. INSTALL CHAIN SUB-ASSEMBLY (See  INSTALLATION  ) 
  4. INSTALL CHAIN TENSIONER SLIPPER (See  INSTALLATION  ) 
  5. INSTALL CRANKSHAFT POSITION SENSOR PLATE NO.1 (See  INSTALLATION  ) 
  6. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL (See  INSTALLATION  ) 
  7. INSTALL TIMING CHAIN OR BELT COVER SUB-ASSEMBLY (See  INSTALLATION  ) 
  8. INSTALL CHAIN TENSIONER ASSEMBLY NO.1 (See  INSTALLATION  ) 
  9. INSTALL CRANKSHAFT PULLEY (See  INSTALLATION  ) 
  10. INSTALL CRANKSHAFT POSITION SENSOR (See  INSTALLATION  ) 
  11. INSTALL WATER PUMP ASSEMBLY (See  REMOVAL  ) 
  12. INSTALL ENGINE MOUNTING BRACKET RH (See  INSTALLATION  ) 
  13. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY (See  INSTALLATION  ) 
  14. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY (See  INSTALLATION  ) 
  15. INSTALL IGNITION COIL ASSEMBLY (See  INSTALLATION  ) 
  16. INSTALL ENGINE MOUNTING INSULATOR RH (See  INSTALLATION  ) 
  17. INSTALL GENERATOR ASSEMBLY (See  INSTALLATION  ) 
  18. INSTALL VANE PUMP ASSEMBLY (See  INSTALLATION  ) 
  19. INSTALL FAN AND GENERATOR V BELT 
  20. ADD ENGINE COOLANT (See  COOLANT  ) 
  21. ADD ENGINE OIL (See  REPLACEMENT   ) 
  22. CONNECT BATTERY NEGATIVE TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  23. INSPECT FOR COOLANT LEAK (See  COOLING SYSTEM  ) 
  24. INSPECT FOR OIL LEAK 
  25. INSTALL CYLINDER HEAD COVER NO.2 (See  INSTALLATION  ) 
  26. INSTALL ENGINE UNDER COVER RH 
  27. INSTALL FRONT WHEEL RH 

    Torque: 100 N*m (1,050 kgf*cm, 76 ft.*lbf) 

scientia non olet · About LEMON Manuals