Inspection Procedure

1. Disconnect the C11 connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester connection	Condition	Specified condition
   C11-40 - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester connection	Condition	Specified condition
   C11-1 - Body ground	Always	10 to 14 V
   C11-21 - Body ground	Ignition switch ACC or ON	10 to 14 V

   Fig 1: Inspecting Combination Meter Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK : REPLACE COMBINATION METER ASSEMBLY