Data List / Active Test

HINT:

Using the intelligent tester to read the DATA LIST allows the values or states of switches, sensors, actuators, and other items to be read without removing any parts. This non intrusive inspection can be very useful as intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

1. Warm up the engine.
2. Ignition switch off.
3. Connect the intelligent tester to the DLC3.
4. Turn the ignition switch to the ON position.
5. Turn the tester ON.
6. Enter following menus: DIAGNOSIS / OBD/MOBD / ENGINE / DATA LIST
7. Check the values by referring to the table below.

   ENGINE: 

   NORMAL CONDITION CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ENGINE SPD	Engine speed / Min.: 0 rpm, Max.: 16,383 rpm	Almost the same as the actual engine speed (When engine is running)	-
   COOLANT TEMP	Coolant temperature / Min.: -40°C (-40°F), Max.: 140°C (284°F)	After warming up: 80 to 95°C (176 to 203°F)	If the value is "-40°C (-40°F)" or "140°C (284°F)", sensor circuit is open or shorted.

   ABS/TRAC/VSC: 

   NORMAL CONDITION CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   FR/FL/RR/RL WHEEL SPD	Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)	Almost same as actual speed (When driving)	-