LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Land Cruiser >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Ignition System) >> Ignition Coil >> Installation

Ignition Coil: Installation

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL IGNITION COIL ASSEMBLY 
    1. Install the ignition coil with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the connector.
    Fig 1: Installing Ignition Coil
    G04436342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT ENGINE WIRE 
    1. Connect the 2 engine wire clamps to the cylinder head cover LH side.
  3. INSTALL INTAKE AIR CONNECTOR PIPE (See  INSTALLATION  ) 
  4. INSTALL V-BANK COVER SUB-ASSEMBLY (See  INSTALLATION  ) 
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  6. PERFORM INITIALIZATION 
    1. Perform INITIALIZATION .
      NOTE: Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals