Front Heater Unit: Installation

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HEATER UNIT
1. Install the heater unit with the 4 nuts.
2. Connect the connector.
  
  Fig 1: Installing Heater Unit Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the lower defroster nozzle.
INSTALL FRONT COOLING UNIT
INSTALL INSTRUMENT PANEL AND REINFORCEMENT

Fig 2: Installing Instrument Panel & Reinforcement
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT WATER HOSE
1. Connect the water hoses to the heater radiator pipes and attach the clips.
  HINT:
  - Push the water hose onto the heater radiator pipe to the second ridge on the pipe.
  - Install a hose clip in the position as shown.
    
    Fig 3: Connecting Water Hose
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see TERMINALS OF ECU ).
ADD ENGINE COOLANT (See COOLANT )
WARM UP ENGINE (See REPLACEMENT )
CHECK ENGINE COOLANT FOR LEAKS (See COOLING SYSTEM )