LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Land Cruiser >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Starter Relay >> On-Vehicle Inspection

On-Vehicle Inspection

  1. REMOVE STARTER RELAY (Marking: STARTER) 
    1. Remove the engine room relay block cover.
    2. Remove the starter relay from the engine room relay block.
  2. INSPECT STARTER RELAY 
    1. Measure the resistance of the starter relay.

      Standard resistance 

      STARTER RELAY

      Tester Connection Specified Condition
      3 - 5 10 kΩ or higher
      3 - 5 Below 1 Ω
      (when battery voltage is applied to terminals 1 and 2)
      Fig 1: Inspecting Starter Relay
      G04436384Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the relay.

  3. INSTALL STARTER RELAY 
scientia non olet · About LEMON Manuals