LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Limited, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 39 (Brake Control System - Hybrid) >> Brake Control Power Supply >> Removal

Brake Control Power Supply: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE DECK BOARD SUB-ASSEMBLY (w/o Rear No. 2 Seat)  (See REMOVAL )
  2. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Rear No. 2 Seat)  (See REMOVAL )
  3. REMOVE DECK BOARD NO.2 SUB-ASSEMBLY 
  4. REMOVE DECK BOARD NO.3 SUB-ASSEMBLY 
  5. REMOVE DECK FLOOR BOX REAR  (See REMOVAL )
  6. REMOVE DECK FLOOR BOX FRONT (w/o Rear No. 2 Seat)  (See REMOVAL )
  7. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  8. REMOVE DECK SIDE TRIM BOX LH  (See REMOVAL )
  9. REMOVE BRAKE CONTROL POWER SUPPLY 
    1. Disconnect the brake control power supply connector
      2. Fig 1: Locating Nuts, Bolt And Brake Control Power Supply
      G05202846Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts, bolt and the brake control power supply with bracket.
    3. Remove the 4 bolts and 2 brackets.
      4. Fig 2: Locating Brackets And Bolts
      G05202847Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals