Rear Wheel Alignment: Inspection

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT TIRE
1. Inspect the tires (see TIRE AND WHEEL SYSTEM ).
MEASURE VEHICLE HEIGHT
1. Measure the vehicle height (see ADJUSTMENT ).

INSPECT TOE-IN

Standard toe-in

SPECIFIED CONDITION CHART

Item	Specified Condition
Toe-in (total)	A + B: 0° 18' +-15' (0.30° +-0.25°) C - D: 3.0 +-2.5 mm (0.12 +-0.10 in.)

HINT:

Measure "C - D" only when "A + B'" cannot be measured.
If the toe-in is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.

Fig 1: Measuring Wheel Alignment

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT CAMBER

Install the camber-caster-kingpin gauge or set the vehicle on a wheel alignment tester.

Inspect the camber.

Standard camber

SPECIFIED CONDITION CHART

Item	Specified Condition
Camber Right-left error	-1° 30' +-30' (-1.50 +-0.5°) 30' (0.5°) or less

HINT:

Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.