Battery Plug: Installation

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL BATTERY PLUG
1. Temporarily fasten the service plug.
2. Install the service plug to the upper battery carrier with the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
3. Assemble the connector clamp.
INSTALL NO. 1 WIRE HARNESS PROTECTOR COVER
1. Temporarily fasten the wire harness protector cover to the service plug.
2. Install the wiring harness protector cover through the service plug with 2 new nuts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 1: Installing Service Plug To Upper Battery Carrier
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BATTERY CLAMP PAD
CAUTION: Wear insulating gloves.
1. Install a new clamp pad (the battery carrier cushion).
INSTALL BATTERY COVER (See INSTALLATION )
INSTALL HV BATTERY ASSEMBLY
1. Install the HV battery to the vehicle (see INSTALLATION ).
  
  Fig 2: Installing Battery Clamp Pad
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SERVICE PLUG GRIP (See REMOVAL )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
INSTALL REAR NO. 3 FLOOR BOARD (See INSTALLATION )
INSTALL REAR DECK FLOOR BOX (See INSTALLATION )
INSTALL REAR NO. 2 FLOOR BOARD (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.