Section 11 (Air Conditioning): Condenser: Reassembly

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL COOLER DRYER
1. Using pliers, install the cooler dryer to the modulator.
2. Install a new O-ring to the cap.
  
  Fig 1: Installing Cooler Dryer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Sufficiently apply compressor oil (ND-OIL 11) to the O-ring and cap fitting surface.
  Compressor oil: ND-OIL 11 or equivalent
  NOTE:
  - Do not use any compressor oil other than ND-OIL 11.
  - If any compressor oil other than ND-OIL 11 is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
    
    Fig 2: Identifying O-Ring And Cap Fitting Surface
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a 14 mm hexagon wrench, install the cap to the modulator.
  Torque: 2.9 N*m (30 kgf*cm, 25 in.*lbf)
  
  Fig 3: Installing Cap To Modulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002