Blower Unit: Disassembly

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE AIR INLET SERVO MOTOR
1. Remove the 3 screws and air inlet servo motor.
  
  Fig 1: Removing Air Inlet Servo Motor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER MOTOR CONTROL
1. Disconnect the connector.
2. Remove the 2 screws and blower motor control.
  
  Fig 2: Removing Blower Motor Control
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 COOLER WIRING HARNESS SUBASSEMBLY
1. Remove the 5 screws and blower motor cover.
  
  Fig 3: Removing Blower Motor Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the No. 2 cooler wiring harness from the blower with fan motor.
  
  Fig 4: Removing No 2 Cooler Wiring Harness From Blower
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER WITH FAN MOTOR SUBASSEMBLY
1. Remove the 3 screws and blower with fan motor.
  
  Fig 5: Removing Blower With Fan Motor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLEAN AIR FILTER
1. Detach the 2 claws and then remove the air filter cover plate with the clean air filter.
2. Remove the clean air filter from the air filter cover plate.
  
  Fig 6: Removing Clean Air Filter
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002