Knock Sensor: Installation

INSTALL KNOCK SENSOR
1. Install the sensor with the nut.
  Torque: 20 Nm (199 kgf*cm, 14 ft.*lbf)
  
  HINT:
  
  Angling the knock sensor below the horizontal (below 0°) is recommended.
  
  Fig 1: Angling Knock Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the sensor connector.
INSTALL INTAKE MANIFOLD
1. Install a new gasket and the intake manifold with the 5 bolts and 2 nuts.
  Torque: 30 Nm (305 kgf*cm, 22 ft.*lbf)
INSTALL THROTTLE BODY ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (See INSTALLATION )
ADD ENGINE COOLANT (See ON-VEHICLE INSPECTION )
CHECK ENGINE COOLANT LEAK (See ON-VEHICLE INSPECTION )

Fig 2: Installing Gasket And Intake Manifold With Bolts And Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002