Transmission Control Cable Assembly: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY W/ PASSENGER AIR BAG ASSEMBLY
HINT:

(See REMOVAL )
REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
1. Remove the nut from the control shaft lever.
2. Disconnect the control cable from the control shaft lever.
  
  Fig 1: Locating Transmission Control Cable Assembly Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the clip and disconnect the control cable from the control cable bracket.
  
  Fig 2: Locating Control Cable Bracket Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the control cable from the control cable clamp.
  
  Fig 3: Identifying Control Cable To Control Cable Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Disconnect the cable end from the rod of the floor shift assembly.
  
  Fig 4: Locating Cable End From Rod Of Floor Shift Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the 2 nuts.
  
  Fig 5: Installing Control Cable Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the 3 bolts.
8. Pull out the control cable from the body.
  
  Fig 6: Locating Control Cable Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002