Rear Stabilizer Bar: Installation

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR STABILIZER BAR
1. Install the stabilizer bar so that the mark position faces towards the vehicle's rear right. Hold the bolts and tighten the nuts.
  Torque: 149 N*m (1,520 kgf*cm, 110 ft.*lbf)
  
  Fig 1: Installing Rear Stabilizer Bar
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR AXLE BEAM DAMPER
1. Install the rear axle beam damper to the center of the rear axle beam.
  
  Fig 2: Installing Rear Axle Beam Damper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002