LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Base, 2.4 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Suspension System) >> Front Stabilizer Bar >> Removal

Front Stabilizer Bar: Removal

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  2. REMOVE COLUMN HOLE COVER SILENCER SHEET (See  REMOVAL  ) 
  3. DISCONNECT STEERING SLIDING YOKE SUB-ASSEMBLY (See  REMOVAL  ) 
  4. DISCONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  5. REMOVE FRONT WHEEL 
  6. REMOVE FRONT STABILIZER LINK ASSEMBLY LH 
    1. Remove the 2 nuts and front stabilizer link LH.

    HINT:

    Use a 6 mm hexagon wrench to hold the stud if the ball joint turns together with the nut.

    Fig 1: Removing Nuts And Front Stabilizer Link LH
    G04474431Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. DISCONNECT NO. 2 TIE ROD END SUB-ASSEMBLY (See  REMOVAL  ) 
  8. DISCONNECT NO. 1 TIE ROD END SUB-ASSEMBLY (See  REMOVAL  ) 
  9. REMOVE FLOOR PANEL BRACE FRONT (See  REMOVAL  ) 
  10. REMOVE FRONT EXHAUST PIPE ASSEMBLY (See  REMOVAL  ) 
  11. DISCONNECT FRONT NO. 1 STABILIZER BRACKET LH 
    1. Remove the 2 bolts and the No. 1 stabilizer bracket from the front suspension crossmember.
  12. DISCONNECT FRONT NO. 1 STABILIZER BRACKET RH 

    HINT:

    Remove the RH side following the same procedures as the LH side.

  13. REMOVE STEERING INTERMEDIATE SHAFT (See  REMOVAL  ) 
  14. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY 
  15. REMOVE STEERING GEAR ASSEMBLY (See  REMOVAL  ) 
  16. REMOVE FRONT NO. 1 STABILIZER BAR BUSH 
    1. Remove the 2 front No. 1 stabilizer bar bushes from the stabilizer bar.
  17. REMOVE FRONT STABILIZER BAR 
    1. Remove the front stabilizer bar from the right side of the vehicle.
scientia non olet · About LEMON Manuals