How To Proceed With Troubleshooting

HINT:

The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN communication system.
*: Use the intelligent tester.

VEHICLE BROUGHT TO WORKSHOP
CUSTOMER PROBLEM ANALYSIS
CONNECT INTELLIGENT TESTER TO DLC3*
CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
Refer to DTC CHECK/CLEAR .
VISUAL INSPECTION
SETTING CHECK MODE DIAGNOSIS*
Refer to CHECK MODE PROCEDURE .

PROBLEM SYMPTOM CONFIRMATION

Refer to ROAD TEST .

Result

RESULT TABLE

Result	Proceed to
Symptom does not occur	A
Symptom occurs	B

B: GO TO STEP 9

A: Go TO NEXT STEP

SYMPTOM SIMULATION
Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE .

DTC CHECK*

Refer to DTC CHECK/CLEAR .

Result

RESULT TABLE

Result	Proceed to
DTC is not output	A
DTC is output	B

B: GO TO STEP 17

A: Go TO NEXT STEP

BASIC INSPECTION
Refer to AUTOMATIC TRANSMISSION FLUID .

Refer to PARK/NEUTRAL POSITION SWITCH .

Refer to FLOOR SHIFT ASSEMBLY .

NG: GO TO STEP 19

OK: Go TO NEXT STEP
MECHANICAL SYSTEM TEST
Refer to MECHANICAL SYSTEM TEST .

NG: GO TO STEP 16

OK: Go TO NEXT STEP
HYDRAULIC TEST
Refer to HYDRAULIC TEST .

NG: GO TO STEP 16

OK: Go TO NEXT STEP
MANUAL SHIFTING TEST
Refer to MANUAL SHIFTING TEST .

NG: GO TO STEP 15

OK: Go TO NEXT STEP
PROBLEM SYMPTOMS TABLE CHAPTER 1
Refer to PROBLEM SYMPTOMS TABLE .

NG: GO TO STEP 18

OK: Go TO NEXT STEP
PROBLEM SYMPTOMS TABLE CHAPTER 2
Refer to PROBLEM SYMPTOMS TABLE .
PART INSPECTION
NEXT: GO TO STEP 19
DTC TABLE
Refer to DIAGNOSTIC TROUBLE CODE TABLE .
CIRCUIT INSPECTION
REPAIR OR REPLACE
CONFIRMATION TEST
NEXT: END