Rear Stabilizer Bar: Installation

1. Install the 2 stabilizer bushes onto the stabilizer bar.

   HINT:

   Install the stabilizer bush onto the outer side of the bush stopper on the stabilizer bar.

   Fig 1: Identifying Rear Stabilizer Bushes

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the stabilizer bar and 2 stabilizer bracket covers with the 4 bolts.

   Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf) 

   Fig 2: Identifying Rear Stabilizer Bar & Rear Stabilizer Bracket Covers With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the stabilizer link with the nut.

   Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf) 

   HINT:

   If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

   Fig 3: Identifying Rear Stabilizer Link Assembly Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 No. 1 retainers, 2 cushions and No. 2 retainer.
3. While holding the stabilizer link with a spanner, install a new nut.

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   Fig 4: Identifying Stabilizer Link Cushion

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. The installation procedure for the RH side is the same as that for the LH side.

Torque: 112 N*m (1, 137 kgf*cm, 82 ft.*lbf)