Front Shock Absorber With Coil Spring: Removal

REMOVE FRONT WHEELS
REMOVE ENGINE UNDER COVER SUB-ASSEMBLY
SEPARATE FRONT STABILIZER LINK ASSEMBLY LH
1. Remove the nut and separate the stabilizer link from the steering knuckle.
  HINT:
  
  If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
  
  Fig 1: Locating Front Stabilizer Link Assembly And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT:

The removal procedure for the RH side is the same as that for the LH side.
REMOVE FRONT STABILIZER BAR (See REMOVAL )
SEPARATE TIE ROD END SUB-ASSEMBLY (See REMOVAL )
REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
1. Remove the bolt, nut and washer.
  
  Fig 2: Identifying Front Shock Absorber With Coil Spring, Bolt & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 3 nuts on the upper side of the front shock absorber with coil spring.
3. Remove the front shock absorber with coil spring.
  
  Fig 3: Identifying Upper Side Of Front Shock Absorber With Coil Spring & Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002