Front Seat Inner Belt Assembly: Installation

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (See PRECAUTION ).

HINT:

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

INSTALL FRONT SEAT INNER BELT ASSEMBLY
1. Install the front seat inner belt with the bolt.
  Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
  
  NOTE: Do not place the front seat inner belt over the convex areas of the front seat frame adjuster.
2. Install the wire harness into the claw of the front seat cushion inner shield.
  
  Fig 1: Identifying Front Seat Inner Belt & Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. for Driver Side:
  1. Install the 2 clamps and the 2 connectors.
  2. Connect the seat position sensor connector.
    
    Fig 2: Identifying Clamps & Connectors
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. for Front Passenger Side:
  1. Install the clamp and the connector.
  2. Connect the buckle switch connector.
INSTALL FRONT SEAT ASSEMBLY (See INSTALLATION )
INSTALL FRONT SEAT TRACK COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(See DIAGNOSIS SYSTEM )

Fig 3: Identifying Buckle Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002