Back Door Lock: Installation

INSTALL BACK DOOR LOCK
1. Apply MP grease to the sliding and rotating areas of the back door lock.
2. Using "Torx" socket wrench T30, install the back door lock with the 3 screws.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Identifying Back Door Lock Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Tighten bolt A.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
4. Connect the connector.
5. Connect the back door lock rod.
  
  Fig 2: Identifying Back Door Lock Rod
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BACK DOOR LOCK CYLINDER
1. Install the back door lock cylinder.
  
  Fig 3: Identifying Back Door Lock Cylinder
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the retainer, then connect the 2 clamps.
  
  Fig 4: Connecting Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BACK DOOR SERVICE HOLE COVER (See REASSEMBLY )
INSTALL BACK DOOR TRIM BOARD (See REASSEMBLY )
INSTALL DOOR TRIM RETAINER CAP (See REASSEMBLY )
INSTALL BACK DOOR TRIM COVER RH (See REASSEMBLY )
INSTALL BACK DOOR TRIM COVER LH
HINT:

Use the same procedure as for the RH side.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)