Rear Wheel Alignment: Adjustment

INSPECT TIRES
HINT:

See INSPECTION
MEASURE VEHICLE HEIGHT
HINT:

See FRONT WHEEL ALIGNMENT

NOTE: Before inspecting wheel alignment, adjust the vehicle height to the specified value.
INSPECT TOE-IN
Coupe:
TOE-IN COUPE SPECIFICATION

Toe-in (total) A + B: 0°24' +-12' (0.40° +- 0.20°)
C - D: 4 +- 2 mm (0.16 +- 0.08 in.)

Convertible:
TOE-IN CONVERTIBLE SPECIFICATION

Toe-in (total) A + B: 0°26' +-12' (0.43° +- 0.20°)
C - D: 4 +- 2 mm (0.16 +- 0.08 in.)

HINT:
- Measure "C - D" only when "A + B" cannot be measured.
- If toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.
ADJUST TOE-IN
1. Measure the lengths of the right and left No. 2 lower suspension arms.
  No. 2 lower suspension arm length difference: 1.5 mm (0.06 in.) or less
  
  If the left-right difference is larger than 1.5 mm (0.06 in.), adjust it by following the procedures below.
  
  Fig 1: Identifying Suspension Arms Length
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Loosen the 2 lock nuts.
3. Turn the right and left adjusting tubes by an equal amount to adjust toe-in.
  HINT:
  - Try to adjust toe-in to the center value.
  - One turn of each adjusting tube will adjust toe-in by approximately 1.2° (1°12'), 10.8 mm (0.425 in.).
4. Torque the 2 lock nuts.
  Torque: 56 N*m (570 kgf*cm, 41 ft.*lbf)
  
  Fig 2: Tightening Lock Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT CAMBER

Coupe (sport pack):

CAMBER COUPE (SPORT PACK) SPECIFICATION

	2AZ-FE	3MZ-FE
Camber	-1°21'+-45'(-1.35°+-0.75°)	-1°23'+-45'(-1.38°+-0.75°)
Right-left error	45' (0.75°) or less	45' (0.75°) or less

Coupe (except sport pack):

CAMBER COUPE (EXCEPT SPORT PACK) SPECIFICATION

	2AZ-FE	3MZ-FE
Camber	-1°21' +- 45' (-1.35° +- 0.75°)	-1°22' +- 45' (-1.37° +- 0.75°)
Right-left error	45' (0.75°) or less	45' (0.75°) or less

Convertible:

CAMBER CONVERTIBLE SPECIFICATION

Camber	-1°20'+-45'(-1.33°+-0.75°)
Right-left error	45' (0.75°) or less

HINT:

Camber is not adjustable. If the measurement is not within the specification, inspect the suspension parts for damage and/or wear, and replace them if necessary.