Knock Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL KNOCK SENSOR
1. Install the sensor with the nut.
  Torque: 20 N*m (199 kgf*cm, 14 ft.*lbf)
  
  HINT:
  
  Angling the knock sensor below the horizontal (below 0°) is recommended.
2. Connect the sensor connector.
  
  Fig 1: Installing Knock Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE MANIFOLD
1. Install a new gasket and the intake manifold with the 5 bolts and 2 nuts.
  
  Fig 2: Identifying Gasket And Intake Manifold With Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf)
INSTALL THROTTLE BODY ASSEMBLY
HINT:

See REMOVAL .
INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
CHECK CONNECTION OF VACUUM HOSE
ADD ENGINE COOLANT
HINT:

See COOLANT
CHECK FOR ENGINE COOLANT LEAKS
HINT:

See REPLACEMENT