Section 6 (Engine Control System (2AZ-FE)): ECM: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL ECM BRACKET NO.2
1. Install the ECM bracket with the 2 screws.
  
  Fig 1: Locating ECM Bracket No.2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ECM BRACKET
1. Install the ECM bracket with the 2 screws.
  
  Fig 2: Locating ECM Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ECM
1. Install the 2 wire harness clamps.
2. Connect the 5 ECM connectors.
3. Install the ECM with the 2 nuts.
  
  Fig 3: Locating ECM
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
INSTALL INSTRUMENT PANEL FINISH LOWER PANEL RH
HINT:

See INSTALLATION
INSTALL INSTRUMENT PANEL NO.1 UNDER COVER SUB-ASSEMBLY
HINT:

See INSTALLATION
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:

See INSTALLATION
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

See INSTALLATION
CONNECT BATTERY NEGATIVE TERMINAL
SYSTEM INITIALIZE
HINT:

See CUSTOMIZE PARAMETERS