On-Vehicle Inspection
- CHECK ACCELERATOR PEDAL ROD
- Put the engine in INSPECTION MODE PROCEDURE .
- Warm up the engine.
- Turn the power switch off.
- Connect the intelligent tester to the DLC3.
- Turn the power switch ON (IG).
- Turn the tester on.
- Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST.
- Check the values by referring to NORMAL CONDITION TABLE .NORMAL CONDITION TABLE
Intelligent Tester Display Measurement: Range (Display) Normal Condition *1 Diagnostic Note ACCEL POS #1 (Accelerator pedal position #1) Accelerator pedal position sensor No. 1/ Min.: 0%, Max.: 100% Accelerator pedal depressed: Changes with accelerator pedal pressure - ACCEL POS #2 (Accelerator pedal position #2) Accelerator pedal position sensor No. 2/ Min.: 0%, Max.: 100% Accelerator pedal depressed: Changes with accelerator pedal pressure -