Typical Enabling Conditions
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever these DTCs are not present | P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (TP) |
| Time after ignition switch OFF to ON (IG) | 3 seconds or more |
| Engine | Running |
| Transmission counter gear speed | 300 rpm or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON (IG) |
| Starter | OFF |
| Either of the following conditions is met | Condition 1 or 2 |
| 1 All of the following conditions are met | Conditions (a) (b) and (c) |
| (a) ECT | 20°C (68°F) or more |
| (b) ECT sensor fail | Not detected |
| (c) Time after PNP switch ON to OFF | 10 seconds or more |
| 2 All of the following conditions are met | Conditions (a), (b) and (c) |
| (a) ECT | Less than 20°C (68°F) |
| (b) ECT sensor fail | Detected |
| (c) Time after PNP switch ON to OFF | 30 seconds or more |