LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Avalon XLS >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> Emission Control System >> Canister >> Installation

Emission Control System: Canister: Installation

  1. INSTALL CHARCOAL CANISTER ASSEMBLY 
    1. Install the 2 bolts, clip and charcoal canister.

      Torque: 36 N*m (367 kgf*cm, 27 ft.*lbf) 

    2. Connect the purge line hose to the charcoal canister.
    3. Connect the wire harness clamp.
    4. Connect the vapor pressure sensor connector.
    5. Connect the charcoal canister filter sub-assembly to the charcoal canister.
    6. Connect the fuel tank vent hose to the charcoal canister.
  2. INSTALL FUEL TANK ASSEMBLY  (See INSTALLATION )
  3. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3  (See INSTALLATION )
  4. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.2  (See INSTALLATION )
  5. INSTALL EXHAUST PIPE ASSEMBLY CENTER 
  6. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY 
  7. ADD FUEL 
  8. CONNECT BATTERY NEGATIVE TERMINAL 
  9. CHECK FOR FUEL LEAKS 
  10. CHECK FOR EXHAUST GAS LEAKS 
  11. INSTALL REAR FLOOR SERVICE HOLE COVER 
  12. INSTALL REAR SEAT CUSHION ASSEMBLY  (See INSTALLATION )
  13. PERFORM SYSTEM INITIALIZE 

    Some systems need initialization when disconnecting the battery terminal.

scientia non olet · About LEMON Manuals