Inspection Procedure

1. Measure the voltage according to the value(s) in the table below.

   Voltage 

   TRANSPONDER KEY ECU ASSEMBLY
   
   

   Tester Connection	Condition	Specified Condition
   D33-1 (+B) - D33-16 (GND)	Always	10 to 14 V
   D33-2 (IG) - D33-16 (GND)	Ignition switch OFF	Below 1 V
   D33-2 (IG) - D33-16 (GND)	Ignition switch ON	10 to 14 V

Fig 1: Identifying D33 Transponder Key ECU Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: Go to step 2 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

1. Disconnect the D33 ECU connector.
2. Measure the resistance according to the value(s) in the table below.

   Resistance 

   GROUND CIRCUIT
   
   

   Tester Connection	Condition	Specified Condition
   D33-16 (GND) - Body ground	Always	Below 1 Ω

Fig 2: Checking Harness And Connector (Ground Circuit)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)