Inspection Procedure

1. Remove the outside handle.
   Fig 1: Identifying Door Oscillator Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the antenna and door oscillator connectors.
Fig 2: Identifying Antenna Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the resistance between the oscillator and the antenna to check for an open circuit in the wire harness.

   Resistance: 

   Below 1 Ω 

4. Measure the resistance between the oscillator and the antenna to check for a short circuit in the wire harness.

   Resistance: 

   10 kΩ or higher 

   HINT:

   Refer to the wiring diagram for connection of each terminal.

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  .