Valve Body Assembly: Installation

1. Insert the pin of the lever into the hole of the manual valve.
   Fig 1: Identifying Pin Of Lever

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install 3 new drum seal gaskets onto the transmission case.
3. Install the 19 bolts.

   Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

   HINT:

   Each bolt length is indicated below.

   Standard bolt length: 

   36 mm (1.42 in.) for bolt A 

   25 mm (0.98 in.) for bolt B 

   Fig 2: Identifying Transmission Valve Body Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the 7 connectors to the solenoid valves.
2. Install the clamp with the 2 bolts.

   Torque: 

   10 N*m (100 kgf*cm, 7 ft.*lbf) for bolt A 

   11 N*m (112 kgf*cm, 8 ft.*lbf) for bolt B 

   Fig 3: Identifying Transmission Wire Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT:

   Each bolt length is indicated below.

   Standard bolt length: 

   12 mm (0.47 in.) for bolt A 

   36 mm (1.42 in.) for bolt B 

3. Connect the ATF temperature sensor.

   Sensor wire harness: 

   SENSOR WIRE HARNESS
   
   

   Wire harness	Color
   for liner control	Orange
   for oil temp, warning light	Blue

1. Install a new O-ring and the oil strainer with the 4 bolts.

   Torque: 10 N*m (100 kgf*cm, 7 ft.*lbf) 

   Fig 4: Identifying Valve Body Oil Strainer Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

1. Install the new gasket and the oil pan with the 20 bolts.

   Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf) 

   Fig 5: Identifying Oil Pan Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

(See ADJUSTMENT  )

HINT:

(See ADJUSTMENT  )