How To Proceed With Troubleshooting

HINT:

Troubleshoot in accordance with the procedures

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 
3. DTC CHECK 
   1. Check for DTCs and make a note of the code that is output.
   2. Delete the DTC.

      HINT:

      See DIAGNOSTIC TROUBLE CODE CHART 

   3. Check if the DTC will be output once again when the problem symptom is simulated based on the noted code.
      1. With an output of the code, proceed to A.
      2. Without an output of the code, proceed to B.

   A: GO TO STEP  5

   B: GO TO NEXT STEP 

4. PROBLEM SYMPTOMS TABLE 

   HINT:

   See PROBLEM SYMPTOMS TABLE 

5. PERFORM TROUBLESHOOTING 
   1. Operation check.

      HINT:

      See OPERATION CHECK 

   2. Circuit inspection.
6. ADJUST, REPAIR OR REPLACE 
7. RESET POWER WINDOW REGULATOR MOTOR 
   1. If any of the power window switch illuminations is blinking after repair, reset the power window.
      1. Turn the ignition switch ON.
      2. Open the driver side door glass.
      3. Fully pull up the AUTO switch of the power window master switch until the door glass is fully closed.
      4. Check that the AUTO UP/DOWN function operates normally.

   NEXT: END