Data List / Active Test
- USING INTELLIGENT TESTER
- Connect the intelligent tester to the DLC3.
- Monitor the ECU data by following the prompts on the tester screen.
HINT:
The intelligent tester has a "Snapshot" function which records the monitored data. Refer to the intelligent tester operator's service information for further details.
- DATA LIST
HINT:
Using the DATA LIST displayed on the intelligent tester, the value of the switch, sensor, actuator, etc. can be read without part removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.
- Connect the intelligent tester to the DLC3.
- Turn the engine switch on (IG).
- Read the DATA LIST according to the display on the tester.
BACK DOOR ECU:
DATA LIST - BACK DOOR ECUItem Measurement Item/ Display (Range) Normal Condition Diagnostic Note WIPER RTRCT SW Rear wiper retract switch/ON or OFF ON: Rear wiper retract switch is in ON position
OFF: Rear wiper retract switch is in OFF position- KEY SW (UNLK) Rear door lock key switch at UNLOCK position/ON or OFF ON: Rear door lock key switch at UNLOCK is in ON position
OFF: Rear door lock key switch at UNLOCK is in OFF position- KEY SW (LOCK) Rear door lock key switch at LOCK position/ON or OFF ON: Rear door lock key switch at LOCK is in ON position
OFF: Rear door lock key switch at LOCK is in OFF position- P/W POSITION Back door glass position/CLOSE or OPEN CLOSE: Back door glass is in CLOSE position
OPEN: Back door glass is in OPEN position- GLASS POS-1/4 Door glass position (Fully closed -1/4 open) signal/OK or CAUTION OK: Power window is going UP by manual operation CAUTION: CAUTION may be displayed when resistance is applied in each position. In this case, there must be a foreign object stuck in that position- GLASS POS-2/4 Door glass position (1/4 open - 2/ 4 open) signal/OK or CAUTION OK: Power window is going UP by manual operation CAUTION: CAUTION may be displayed when resistance is applied in each position. In this case, there must be a foreign object stuck in that position- GLASS POS-3/4 Door glass position (2/4 open - 3/ 4 open) signal/OK or CAUTION OK: Power window is going UP by manual operation CAUTION: CAUTION may be displayed when resistance is applied in each position. In this case, there must be a foreign object stuck in that position- BODY:
DATA LIST - BODYItem Measurement Item/ Display (Range) Normal Condition Diagnostic Note IGSW Engine switch signal/ ON or OFF ON: Power source mode is on (IG)
OFF: Power source mode is off or on (ACC)- D DOR CTY SW Driver side door courtesy switch signal/ or OFF ON: Driver side door is open
OFF: Driver side door is closed- P DOR CYT SW Front passenger side door courtesy switch signal/ ON or OFF ON: Front passenger side door is open
OFF: Front passenger side door is closed-
- ACTIVE TEST
HINT:
Performing the ACTIVE TEST using the intelligent tester allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten the labor time. It is possible to display the DATA LIST during the ACTIVE TEST.