Inspection Procedure

HINT:

In case of using the hand-held tester, start the inspection from step  1 and in case of not using the hand-held tester, start from step  2.

1. Check headlight control switch using hand-held tester. 

   PREPARATION: 

   Connect the hand-held tester to the DLC3.

   CHECK: 

   Check the headlight control switch using DATA LIST.

   OK: 

   Fig 1: Headlight Control Switch Position

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. OK: Proceed to next circuit inspection shown on  PROBLEM SYMPTOMS TABLE   . 
   2. NG: Go to next step 
2. Check headlight control switch (See  INSPECTION  ). 
   1. NG: Replace headlight control switch. 
   2. OK: Go to next step 
3. Check wire harness and connector between headlight control switch and body ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
   1. NG: Repair or replace wire harness and connector. 
   2. OK: Proceed to next circuit inspection shown on  PROBLEM SYMPTOMS TABLE   .