Throttle Body: Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY

Check the resistance.

Using an ohmmeter, measure the resistance between the terminals.

Standard

TESTER CONNECTIONS AND SPECIFIED CONDITION TABLE

Tester Connection	Specified Condition
1 (M-) - 2 (M+)	0.3 to 100 Ω at 20°C (68°F)
3 (E2) - 5 (VC)	2.0 to 4.0 kΩ at 20°C (68°F)

If the result is not as specified, replace the throttle body.

Fig 1: Measuring Resistance Between Terminals Using Ohmmeter