Section 13 (Charging System): Generator: Installation

WARNING: This page is about a different car, the 2006 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL GENERATOR ASSEMBLY
1. Install the bracket with the bolt.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
2. Install the wire harness clamp stay.
  Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)
3. Install the generator assembly with the 2 bolts.
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
4. Install the nut to the cylinder block.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
5. Connect the generator connector to the generator assembly.
6. Install the generator wire with the nut.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
7. Install the terminal cap.
8. Connect the wire harness clamp.
INSTALL FAN AND GENERATOR V BELT (See step 69 under INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See step 14 under INSTALLATION )
CONNECT BATTERY NEGATIVE TERMINAL
PERFORM INITIALIZATION
1. Some systems need initialization when disconnecting the battery terminal.