Inspection Procedure

HINT:

Read freeze frame data using the intelligent tester or OBD II scan tool. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was LEAN or RICH, and other data from the time the malfunction occurred.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119) 
   1. Connect the intelligent tester to the DLC3.
   2. Turn the ignition switch ON.
   3. Turn the tester ON.
   4. Enter the following the menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
   5. Read DTCs.

      Result 

      ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119)
      
      

      Display (DTC output)	Proceed to
      Only P2119	A
      P2119 and other codes	B

      HINT:

      If any DTCs other than P2119 are output, troubleshoot those DTCs first.

   B: GO TO  DIAGNOSTIC TROUBLE CODE CHART  

   A: GO TO NEXT STEP 

2. CHECK WHETHER DTC OUTPUT RECURS (DTC P2119) 
   1. Clear the DTC (See DTC CHECK/CLEAR  ).
   2. Allow the engine to idle for 15 seconds.
   3. Pull the hand brake and shift the gear to D.
   4. Depress the brake pedal securely and the accelerator pedal fully for 5 seconds.
   5. Read the DTC.

      HINT:

      Actual throttle position (TP) sensor voltage can be confirmed using the intelligent tester [DATA LIST/ALL/ THROTTLE POS #1].

      OK: No DTC output. 

   NG: REPLACE THROTTLE BODY ASSEMBLY 

   OK: NORMAL