How To Proceed With Troubleshooting
HINT:
The intelligent tester can be used at steps 3, 4, 6, and 9.
- Vehicle Brought to Workshop
- Customer Problem Analysis
- Connect the OBD II scan tool or intelligent tester to DLC3
- Check and Clear DTCs and Freeze Frame Data
HINT:
(See DTC CHECK / CLEAR ).
- Visual Inspection
- Setting the Check Mode Diagnosis
HINT:
(See CHECK MODE PROCEDURE ).
- Problem Symptom Confirmation
HINT:
(See PROBLEM SYMPTOMS TABLE ).
Symptom does not occur: Go to step 8
Symptom occurs: Go to step 9
- Symptom Simulation
HINT:
- DTC Check
HINT:
(See DTC CHECK / CLEAR ).
DTC is not output: Go to step 10
DTC is output: Go to step 17
- Basic Inspection
HINT:
(See INSPECTION , WIRING DIAGRAM and ADJUSTMENT ).
NG : Go to step 19
OK : GO TO NEXT STEP.
- Mechanical System Test
HINT:
(See MECHANICAL SYSTEM TESTS ).
NG : Go to step 16
OK : GO TO NEXT STEP.
- Hydraulic Test
HINT:
(See HYDRAULIC TEST ).
NG : Go to step 16
OK : GO TO NEXT STEP.
- Manual Shifting Test
HINT:
(See MANUAL SHIFTING TEST ).
NG : Go to step 15
OK : GO TO NEXT STEP.
- Problem Symptoms Table Chapter 1
HINT:
(See PROBLEM SYMPTOMS TABLE ).
NG : Go to step 18
OK : GO TO NEXT STEP.
- Problem Symptoms Table Chapter 2
HINT:
(See PROBLEM SYMPTOMS TABLE ).
- Part Inspection
Go to step 19
- DTC Chart
HINT:
(See DIAGNOSTIC TROUBLE CODE CHART ).
- Circuit Inspection
- Repair or Replace
- Confirmation Test
NEXT : End