Inspection Procedure
WARNING: This page is about a different car, the 2006 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK WIRE HARNESS (IG, GND)
- Measure the resistance according to the value(s) in WIRE HARNESS (IG, GND) (RESISTANCE)
.
Standard resistance
WIRE HARNESS (IG, GND) (RESISTANCE)Tester Connection Condition Specified value Y1-1 (GND) - Body ground Always Below 1 Ω - Measure the voltage according to the value(s) in WIRE HARNESS (IG, GND) (VOLTAGE)
.
Standard voltage
WIRE HARNESS (IG, GND) (VOLTAGE)Tester Connection Condition Specified value Y1-5 (IG) - Body ground IG switch ON 10 to 14 V
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE YAW RATE SENSOR
- Measure the resistance according to the value(s) in WIRE HARNESS (IG, GND) (RESISTANCE)
.