TRANSFER CASE OIL SEAL (for RH Side): Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSFER CASE RH OIL SEAL
1. Using SST, install a new transfer case RH oil seal into the case to the position shown in the illustration.
  SST 09950-60010 (09951-00360, 09951-00590, 09952-06010), 09950-70010 (09951-07150)
  
  Drive in depth: 33.7 to 34.3 mm (1.3268 to 1.3504 in.)
  
  NOTE: Do not install the oil seal obliquely.
  
  Fig 1: Installing Transfer Case RH Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply small amount of MP grease to the lip of the oil seal.
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT AXLE ASSEMBLY RH
ADD TRANSFER OIL
INSPECT TRANSFER OIL
INSTALL NO. 1 TRANSFER CASE PLUG
1. Install a new gasket and transfer case No. 1 plug.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
ADD TRANSAXLE OIL
INSPECT TRANSAXLE OIL (See INSTALLATION )
INSTALL FRONT WHEELS
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT:

(See ADJUSTMENT )
INSPECT ABS SPEED SENSOR SIGNAL
1. Anti-lock Brake System (See TEST MODE PROCEDURE )
2. Vehicle Stability Control System (See TEST MODE PROCEDURE )