Torque Specifications
WARNING: This page is about a different variant/trim than selected.
P310 HYBRID VEHICLE CONTROL TORQUE SPECIFICATIONS
| Part Tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| W/ converter inverter at Inverter bracket | 21 | 214 | 15 |
| Inverter bracket No.4 at W/ converter inverter | 21 | 214 | 15 |
| No.3 wire frame at W/ converter inverter | 10 | 102 | 7 |
| High voltage cable of front motor at W/ converter inverter | 10 | 102 | 7 |
| Engine wire No.4 at W/ converter inverter | 5.4 | 55 | 48in.lbf |
| Inverter cover at W/ converter inverter | 10 | 102 | 7 |
| Interlock bracket at W/ converter inverter | 10 | 102 | 7 |
| Power steering ECU bracket at W/ converter inverter | 8.0 | 82 | 71in.lbf |
| Inverter reserve tank sub-assembly at W/ converter inverter | 10 | 102 | 7 |
| Engine room wire No.2 at Fusible link block assembly | 8.5 | 87 | 75in.lbf |
| Hybrid vehicle control ECU at Body | 5.5 | 56 | 49in.lbf |
| Water w/ motor and bracket pump assembly at Body | 7.0 | 71 | 62in.lbf |
| Frame side rail plate sub-assembly LH at Body | |||
| Bolt A | 85 | 867 | 63 |
| Bolt B | 32 | 326 | 24 |
| Nut | 32 | 326 | 24 |
| Radiator assembly at Condenser assembly | 5.0 | 51 | 44in.lbf |
| Hood lock support sub-assembly at Body | 7.0 | 71 | 62in.lbf |
| Accelerator pedal rod assembly at Floor | 4.9 | 50 | 43in.lbf |
| Circuit breaker sensor No.1 at W/ converter inverter | 8.0 | 82 | 70in.lbf |
| Rear circuit breaker sensor at Floor | 8.0 | 82 | 70in.lbf |
| No.3 wire frame at Body | 8.5 | 87 | 75in.lbf |
| No.3 wire frame at Hybrid vehicle relay | 9.0 | 92 | 80in.lbf |
| No.3 wire frame at Battery cover assembly | 8.0 | 82 | 72in.lbf |
| No.3 wire frame at Power steering converter assembly | 5.5 | 56 | 49in.lbf |