Data List / Active Test
WARNING: This page is about a different variant/trim than selected.
- READ DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch on.
- Read the DATA LIST according to the display on the tester.
CCS:
DATA LISTItem Measurement Item / Display (Range) Normal Condition Diagnostic Note VEHICLE SPD Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) Actual vehicle speed - MEMORY SPD Cruise control memorized speed / min.: 1 km/h (0.6 mph), max.: 255 km/h (158 mph) Actual stored vehicle speed - THROTTLE Required throttle opening angle / min.: 0°, max.: 125° Actual required throttle opening - CRUISE CONTROL Cruise control system active condition / ON or OFF ON: Cruise control activated
OFF: Cruise control inactivated- MAIN SW (MAIN) Main switch signal (Main CPU) / ON or OFF ON: Main switch ON (Pushed on)
OFF: Main switch OFF (Pushed off)"3" CCS READY M Cruise control system standby condition (Main CPU) / ON or OFF Each time main switch is pushed, ON is displayed and then OFF is displayed "1" CCS INDICATOR M Cruise indicator signal (Main CPU) / ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF"2" CANCEL SW CANCEL switch signal / ON or OFF ON: CANCEL switch ON
OFF: CANCEL switch OFF- SET/COAST SW -/SET switch signal / ON or OFF ON: -/SET switch ON
OFF: -/SET switch OFF- RES/ACC SW +/RES switch signal / ON or OFF ON: +/RES switch ON
OFF: +/RES switch OFF- STP LIGHT SW1-M Stop light switch signal (Main CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- SHIFT D POS PNP switch signal (D position) / ON or OFF ON: Shift lever on D
OFF: Shift lever not on D- VEHICLE SPD CHG Vehicle speed change / ON or OFF ON: Change
OFF: Not change- HINT:
- "3" is OK but "1" is NG --> Hybrid vehicle control ECU failure.
- "1" is OK but "2" is NG --> DTC output or hybrid vehicle control ECU failure.
- "3" is but cruise indicator not turn on --> CRUISE MAIN indicator or wire harness or hybrid vehicle control ECU failure.