DTC Check / Clear

WARNING: This page is about a different variant/trim than selected.

DTC CHECK
1. Connect the intelligent tester to the DLC3.
  1. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Data Link Connector 3 (DLC3).
2. Turn the ignition switch on.
3. Read the DTCs by following the prompts on the tester screen.
  HINT:
  
  Refer to the intelligent tester operator's manual for further details.
  
  Fig 1: Connecting Intelligent Tester To DLC3
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DTC CLEAR
1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch on.
3. Operate the intelligent tester to erase the codes.
  HINT:
  
  Refer to the intelligent tester operator's manual for further details.