DTC Check/Clear

CHECK OUTPUT OF DTC BY DOOR OPEN INDICATOR
1. Inspect the battery positive voltage.
  Voltage: 11 to 14V (when engine is stopped)
2. Check DTC outputs.
  1. Check that the door open indicator turns on when one of the doors is opened.
    HINT:
    
    If the indicator does not turn on, the problem may be among the following: a defective door open indicator LED, a short circuit in the wire harness, a defective courtesy light switch contact or a defective multiplex network body ECU.
  2. Using SST (diagnosis check wire No.2), short-circuit terminals TC (13) and CG (4) of the DLC3.
    SST 09843-18040
    
    NOTE: Do not short-circuit any other terminals.
  3. Turn the ignition switch ON and observe how many times the door open indicator flashes.
    HINT:
    
    When 2 or more codes are output simultaneously, the codes will be displayed in numerical order.
    
    Fig 2: Normal And DTCs 11 And 41 Output Flashing Pattern
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002