ECM (2TR-FE): Replacement

NOTE: Perform REGISTRATION (VIN registration) when replacing the ECM (see REGISTRATION ).

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE GLOVE COMPARTMENT DOOR ASSY (See REPLACEMENT )
REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSY LOWER RH (See REPLACEMENT )
REMOVE ECM
1. Disconnect the 4 connectors.
2. Remove the 2 bolts and nut, then remove the ECM.
  
  Fig 1: Removing Bolts, Nut And ECM
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM BRACKET
1. Remove the 3 screws, then remove the ECM bracket.
  
  Fig 2: Removing 3 Screws And ECM Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM BRACKET NO.2
1. Remove the 2 screws, then remove the ECM bracket No. 2.
  
  Fig 3: Removing 2 Screws And ECM Bracket No.2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ECM BRACKET NO.2
Torque: 3 N.m (32 kgf.cm, 28 in..lbf)
INSTALL ECM BRACKET
Torque: 3 N.m (32 kgf.cm, 28 in..lbf)
INSTALL ECM
Torque: 5 N.m (51 kgf.cm, 44 in..lbf)
INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSY LOWER RH (See REPLACEMENT )
INSTALL GLOVE COMPARTMENT DOOR ASSY (See REPLACEMENT )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See PRECAUTION )
Torque: 3.9 N.m (40 kgf.cm, 35 in..lbf)